Distance between Tappen ND and Steele ND

The distance from Tappen to Steele is 15 miles by road including 13 miles on motorways. Road takes approximately 13 minutes and goes through Crystal Springs.

Click here to load the interactive map
Compare this route in other services:
City
Town
Village
Hamlet
Motorway
Primary
Secondary
Unclassified
Point Distance Time Fuel
Tappen 0 mi 0:00 00 min 0.0 gal
I 94 ND 3 15 mi, 13 min
Steele 15 mi 0:13 13 min 0.5 gal

Frequently Asked Questions

How much does it cost to drive from Tappen to Steele?

Fuel cost: 1.9 USD

This fuel cost is calculated as: (Route length 14.9 mi) / (Fuel consumption 29.4 mpg) * (Fuel price 3.82 USD / gal)

You can adjust fuel consumption and fuel price here.

How long is a car ride from Tappen to Steele?

Driving time: 13 min

This time is calculated for driving at the maximum permitted speed, taking into account traffic rules restrictions.

  • 13 mi with a maximum speed 68 mph = 11 min
  • 1 mi with a maximum speed 31 mph = 1 min

The calculated driving time does not take into account intermediate stops and traffic jams.

How far is Tappen to Steele by land?

The distance between Tappen and Steele is 14.9 mi by road including 13 mi on motorways.

Precise satellite coordinates of highways were used for this calculation. The start and finish points are the centers of Tappen and Steele respectively.

What city is halfway between Tappen and Steele?

The halfway point between Tappen and Steele is Steele. It is located about 7 mi from the exact midpoint by road.

The distance from Steele to Tappen is 15 mi and driving will take about 13 min. The road between Steele and Steele has length 0 mi and will take approximately .

Where is Tappen in relation to Steele?

Tappen is located 13 mi east of Steele.

Tappen has geographic coordinates: latitude 46.87499, longitude -99.6365.

Steele has geographic coordinates: latitude 46.85471, longitude -99.91594.

Which highway goes from Tappen to Steele?

The route from Tappen to Steele follows I 94, ND 3.

Have any questions? Contact us!
<